How do you change a rear axle seal?

Here’s how it goes:

  1. Lift the rear of the truck to take the weight off the wheels.
  2. Remove both rear wheels.
  3. Remove the 8 bolts to take the axle out.
  4. Remove the pin and retaining ring by hand.
  5. Remove the axle nut.
  6. At this point, the hub/drum assembly should slide right out.
  7. Now the axle seal is exposed.

How much does it cost to replace a rear axle seal?

The average cost for axle shaft seal replacement is between $234 and $285. Labor costs are estimated between $194 and $245 while parts are priced at $40.

Is it hard to replace an axle seal?

Axle seals can simply wear out, but the most common cause of failure is improper axle removal or installation. While the metal carrier of the seal is sturdy, the flexible seal is fragile and can be easily torn by a ham-handed installation of an incoming axle.

How long can I drive with a rear axle seal leak?

After a rear differential fluid change, most vehicles will go 20,000 to 40,000 miles before it’s due again. It seals the differential housing, keeping the gear oil inside of the housing so that it can properly lubricate the differential ring and pinion gears.

What causes a rear axle seal to leak?

The most common cause of a leaking axle seal is it improper axle installation or removal. In addition, the axle seal can wear out over time, which can cause it to leak. A leaking axle seal may be covered by your vehicle’s Powertrain Warranty, so check your car’s brochure to see if this is the case.

How bad is an axle seal leak?

The purpose of the axle seal is to keep transmission fluid from leaking. Depending on the size of the leak, it may be okay to drive with a leaking axle seal, but not for very long. If the leaking axle seal does not get fixed soon and the transmission is slipping, you could cause permanent damage to the transmission.

How long does it take to replace axle seal?

The labor time for each is 1.1 hours. An OE axle seal is about $25 and an aftermarket SKF seal is about $13. The axle seal replacement cost in this instance will be around $123 using aftermarket parts or $135 using OE parts. The axle seal on the rear of a 2000 Ford Ranger takes 1.2 hours of labor time.

Can you drive with a rear axle seal leak?

What causes axle seal to leak?

The most common cause of a leaking axle seal is improper axle installation or removal but the axle seal can also wear out over time. If you’re concerned that your axle seal might be leaking, here are a few things to look out for: Oil drops below your vehicle after it has been parked.

When to replace rear axle bearings and seals?

After the axle has been removed inspect the bearing and seal surface to check for wear and scoring and replace if damaged. If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely.

What is the purpose of an axle seal?

An axle seal is the part of the vehicle that connects the axle to the rear differential, or the transmission. The purpose of the axle seal is to keep transmission fluid from leaking.

How much does it cost to replace rear axle seal?

If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.

How do you remove rear axle from differential?

Using a small screwdriver or magnet work the metal “C” clip in a circular motion, This will enable you to remove the clip which will release the axle from the differential. This can take a little time so hang in there.

After the axle has been removed inspect the bearing and seal surface to check for wear and scoring and replace if damaged. If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely.

An axle seal is the part of the vehicle that connects the axle to the rear differential, or the transmission. The purpose of the axle seal is to keep transmission fluid from leaking.

If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.

What causes an axle seal on a car to leak?

Do not push it too far though, as ruining your transmission is an expensive repair. The most common cause of a leaking axle seal is it improper axle installation or removal. In addition, the axle seal can wear out over time, which can cause it to leak.