How do you turn off auto extend on a Kwikee step?
In this case, the override switch must be turned off for the step to retract. Turn the vehicle ignition off and open the door. The step will extend and lock in the ‘down’ position. This is the ‘Auto Extend’ feature.
Why is my Kwikee RV not working properly?
It’s usually the power plug that supplies power to the motor. This plug is a bad design, and the male end does not always make a good connection with the female end. The fix is easy. Just twist the male prongs a bit, and plug it back together. I’ve been through two of these steps, and both had the same issues.
What causes a Kwikee step to stop moving?
When the motor assembly moves the step tread to its extended position, or stops moving because of an obstruction such as a curb or the binding of a damaged or bent step frame, the motor draws a larger amount of current. The control unit senses the larger current draw and shuts off the power to the motor.
How do you install a Kwikee electric step?
After the installation is complete and with the entrance door open, place the step switch in the position for the step to extend when the door is opened and retracted when the door is closed (step assembly follows the door). 2. Close the door. The step should retract and lock in the UP position. 3. Open the door.
It’s usually the power plug that supplies power to the motor. This plug is a bad design, and the male end does not always make a good connection with the female end. The fix is easy. Just twist the male prongs a bit, and plug it back together. I’ve been through two of these steps, and both had the same issues.
What are the step test procedures for Kwikee?
Troubleshooting and Test Procedures The step test procedures outlined in this tip sheet are provided to troubleshoot and test all Kwikee IMGL automatic electric step functions. The procedures are designed to initially check the basic functions of the step separately from the RV wiring to determine whether or not the step is malfunctioning.
What happens if your RV step is not working?
CAUTION: Never work under an RV automatic electric step. Serious injury can occur if the steps extend or retract unintentionally. Always remove power from the steps of your motorhome or travel trailer before working on them. The most common issues electric RV steps face are not retracting and not extending properly.
Where is the power cable on a Kwikee step?
Follow the black wire bundle from the connector to the black box mounted to the step. That’s the Step Controller. You’ll find several colored wires going into the controller. There should also be a power cable from the controller to the step motor. Refer to the Lippert manuals for your specific Kwikee step model for the correct wiring.
Why are the steps on my Kwikee not working?
There are several possibilities that could do what you have now. One is the motor failed, another the control board has failed, or for some reason the motor does not know the steps have reached the stored position and the motor has not powered down.
Where is the lighted switch on Kwikee steps?
Many rigs with Kwikee steps have a lighted switch near the door. When the light is off, the steps will open and close with the door. When the light is on and the RV’s engine is off, they will stay open all the time once extended.
Troubleshooting and Test Procedures The step test procedures outlined in this tip sheet are provided to troubleshoot and test all Kwikee IMGL automatic electric step functions. The procedures are designed to initially check the basic functions of the step separately from the RV wiring to determine whether or not the step is malfunctioning.
