How does a motorhome slide out work?
RV slide outs work by changing from an extended to retracted position depending on whether your RV is set up for camping or driving. They are typically operated through an electrical system on your RV’s control center, where the push of a button can retract or expand the slide.
Where can I get a Fleetwood motorhome slideout system?
Fleetwood Motorhome Slideout Systems Operations Manual 2 7 E. 7th St. Mishawaka, IN 46544 800-334-47 2 Fax 574-256-6743 Contents Introduction System Description Operating the Slideout System 2 Overriding the Slideout System 2 Troubleshooting (Electric Wiring) 3 Preventative Maintenance 4 Power Gear Limited Warranty 4 Fleetwoood
What causes an RV slide out to malfunction?
Typical slideouts are either hydraulic (a larger slide) or electric (a smaller slide): 1 Hydraulic systems Hydraulic systems use the principle of hydraulic pressure and it is more common on larger-sized slides. 2 Electrical systems A variety of electrical issues could cause RV’s slideout to malfunction. 3 Motor issues
What kind of motor does an RV slide out use?
RV’s slideout system is operated by a 12 volt DC electric motor and you need to make sure that you supply it with enough power through a converter or a fully charged 12-volt battery. Your vehicle is leveled. You need to level your vehicle before operating the slideout. Your transit bars are removed.
What should I do Before I slide out my RV?
There are NO obstacles outside. Go outside and make sure there is NOTHING on the way of your slide-out. The slideout pathway should be clear from tables, people, trees, electrical posts, etc.
Where is the slideout motor on a RV?
Locate the slideout motor. It will be mounted to one of the slideout rails. NOTE: If the RV has an underbelly or a cover over the motor, these parts must be removed to access the motor. 4. Rotate the brake lever, on the backside of the motor, counter-clockwise (looking from the rear of the motor) about 1/8 of a turn to the released position.
Where is the override on the slideout room?
Rotate the brake lever, on the backside of the motor, counter-clockwise (looking from the rear of the motor) about 1/8 of a turn to the released position. This will release the brake that holds the room in place. 5. Locate the manual override for the slideout system. 6. The room is now free to move.
How do you turn off the slide out motor?
Press and hold the IN/OUT switch (Fig. 1B) in the OUT position until the room is fully extended and stops moving. 5. Release the switch, which will lock the room into position. NOTE: If the slideout switch is held after the room in fully extended, the control will sense that the room has stopped and will shut off the motor after a few seconds.
What do you need to know about electric slideout system?
1. Level the unit. 2. Verify the battery is fully charged and hooked-up to the electrical system. 3. Remove the transit bars (if so equipped). 4. Press and hold the IN/OUT switch (Fig. 1B) in the OUT position until the room is fully extended and stops moving. 5. Release the switch, which will lock the room into position.
